Failure to follow these instructions could result in bodily injury or property damage.
How to Pressure Cook Foods. .
5.Pouring water into a dry overheated canner may crack the metal.
Before filling Mason jars, test load your canner.
Turn heat to its 2003 nissan murano user manual highest setting until water boils vigorously.Place cooking/canning rack on bottom of canner.Clean the air vent/cover lock occasionally to assure that it operates correctly (see page 4).Table of ConTenTs, important Safeguards.Two-piece vacuum caps seal by the cooling of the contents of the jar, not through pressure of the screw band on the lid.Pressure Canning Fish and Seafood. .Reprocess for the full recommended processing time.



It may be prevented by using fresh products and properly processing, cooling, and storing.
If you are unable to locate the model number of your appliance or the instruction book, please contact our Consumer Service Department.
This will stop when the overpressure plug seals.Do not can overripe foods.Precook beets with 2 inches of the stem and all of the root on, as this helps to retain the juices.If leakage continues, the cover handles may not be fully aligned with the body handles and, therefore, the cover lock cannot engage (see page 5).How to Pressure Cook Foods.Although it is not necessary to use a rack between layers of jars, if you wish to do so, a rack can be ordered from the Presto Consumer Service Department.Flat sour, a type of food spoilage, is caused by canning overripe food or allowing precooked foods to stand in jar too long before processing.Replace the small gasket if cracked or nicked.Do not operate your pressure canner with continual leakage.If you have a Presto deep fryer, the model number is generally found on the bottom of the appliance.It is not tall enough to allow adequate space for quart jars.Storing the canner with the cover locked on may cause unpleasant odors and deform the sealing ring.Flat sour shows no indication of spoilage until jar is opened.How to Pressure Can Foods.If leakage continues, clean or replace the overpressure plug (see page 7).