While sitting in a chair, place your feet on either side of the handle and lean forward on the valve to compress the valve spring.
Step 12, place the valve cover back onto the valve stem.
Search me, home, replacement Parts, krystal Clear Filtration Sanitation Set data g name Easy XTR XTR Filter Filter Clear Filtration Clear Filtration Ground Ground Standard Standard Plus Plus Deluxe Deluxe / / Beds Beds Swim Swim Toys data g name Pool Mats Mats Series Boats.
If the pin doesn't punch out easily, you haven't compress the spring far enough.
Step 7, lift the handle off the valve stem and check the white plastic bearing washer underneath the handle to make sure it is intact.Step 16, turn the power to the pump back.You do not have to remove the whole filter valve to replace the valve spring, only the top handle assembly.For maximum safety turn off the power at the circuit breaker to the pump.The Top Valve Assembly can only be mounted one way with the notches lining.The handle must be installed in this same position.This page does not exist, so we'll automatically redirect you.Again, if it takes more than a couple of taps to insert the pin, you have to compress the spring a little more.Lean a little further but use caution.



The pin may be fluted on one end to make a tighter fit.
Step 15, replace the Top Valve Assembly on top of the Valve Body and secure it with the 6 screws.
Search, occasionally after yamaha yzf r1 service manual pdf years of use, the valve spring may break or become weak.
To Intex Development.
The assembly is upside down and the valve spring is in the center.After you hear the air release, close the drain cap clockwise.Please select your selectContext below.Search Set data g name Easy XTR XTR Filter Filter Clear Filtration Clear Filtration Ground Ground Standard Standard Plus Plus Deluxe Deluxe / / Beds Beds Swim Swim Toys data g name Pool Mats Mats Series Boats data g name Play Series Bubble Jet and.If the valve is operated with the handle mounted 180 degrees off, you will Backwashing when you think you are Filtering and Recirculating when you want to dump water to Waste.Throughout this website, unless otherwise noted, are trademarks used in some countries under license from Intex Marketing Ltd.This washer sometimes cracks and interferes with the rotation of the handle.Don't put your full weight on the valve or you may break.Insert the smooth end of the pin first as shown.





Step 9, slide the valve spring and two washers off the valve stem.
With the spring compressed, tap out the steel pin that holds the handle to the valve stem.